88320
1.INSPECT COOLER COMPRESSOR ASSEMBLY
Check the operation.
Start the engine.
Inspect the compressor pulley.
Compressor shaft rotates along with pulley.
| *a | Component without harness connected
(Magnet Clutch Assembly) |
Inspect the cooler compressor.
Disconnect the connector.
Apply battery voltage to the clutch and check the operation of the clutch.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 1
Battery negative (-) → Body ground |
Magnet clutch is engaged |
If the result is not as specified, replace the compressor.