Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM › from 2015.08
RM19Y0E _59 Vehicle Exterior _003019 WIPER / WASHER _0015271 WIPER AND WASHER SYSTEM W

WIPER / WASHER  WIPER AND WASHER SYSTEM  CUSTOMIZE PARAMETERS  


CUSTOMIZE WIPEPR AND WASHER SYSTEM


HINT:

The following items can be customized.


NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



a.

Customizing with the GTS or Techstream

i.

Connect the GTS or Techstream to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS or Techstream on.


iv.

Enter the following menus: Customize Setting / Rear wiper.


v.

Select the setting by referring to the table below.

Rear wiper
Tester Display Description Default Setting ECU Note
Rr wiper operation interval time Changes the interval time of intermittent operation when the rear wiper switch is in INT position. Mode 2 01:Mode1,10:Mode2,11:Mode3 Main body ECU (Fuse Block Assembly)
HINT:
·

Mode1: Hi

·

Mode2: Normal

·

Mode3: Low



Rr wiper INT position operation Switches the operation mode of the rear wiper when the rear wiper switch is in INT position, between intermittent operation after wiping and only intermittent operation. INT $00:Continous,$01:INT Main body ECU (Fuse Block Assembly) -
Washer-linked Rr wiper Switches the operation mode of the rear wiper when the rear washer is operated with the rear wiper switch off, between washer-linked operation mode and stop mode OFF $00:Washer-linked,$01:OFF Main body ECU (Fuse Block Assembly) -