CHECK MAIN BODY ECU (FUSE BLOCK ASSEMBLY)
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| 3A-1 - Body ground | B - Body ground | Battery power supply | Always | 11 to 14 V |
| 3C-7 - Body ground | G - Body ground | Rear washer motor drive output | Rear washer motor operating | 11 to 14 V |
| Rear washer motor off | Below 1 V | |||
| 3C-8 - Body ground | W - Body ground | Front washer motor drive output | Front washer motor operating | 11 to 14 V |
| Front washer motor off | Below 1 V | |||
| 3D-1 - Body ground | B - Body ground | Front wiper motor low drive output | Front wiper motor low operating | 11 to 14 V |
| Front wiper motor off | Below 1 V | |||
| 3D-7 - Body ground | R - Body ground | Front wiper motor position detection signal | Front wiper motor in low or high operation | Below 1 V ←→ 11 to 14 V |
| Front wiper motor off | Below 1 V | |||
| 3D-8 - Body ground | V - Body ground | Front wiper motor high drive output | Front wiper motor high operating | 11 to 14 V |
| Front wiper motor off | Below 1 V | |||
| 3D-12 - Body ground | G - Body ground | IG power supply | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |||
| 3I-1 - Body ground | W-B - Body ground | Ground | Always | Below 1 V |
| 3L-9 - Body ground | V - Body ground | IG power supply | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |||
| 3L-10 - Body ground | L - Body ground | Rear wiper motor drive output | Rear wiper motor operating | Below 1 V |
| Rear wiper motor off | 11 to 14 V | |||
| 3H-1 - Body ground | V - Body ground | IG power supply | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | |||
| 3F-22 - Body ground | Y - Body ground | Front wiper switch HI position signal | Front wiper switch in HI | Below 1 V |
| Front wiper switch off | 11 to 14 V |
If the result is not as specified, the main body ECU (fuse block assembly) may be malfunctioning.
CHECK COMBINATION SWITCH ECU (SWITCH BASE)
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| E68-1 (2) - Body ground | Y - Body ground | Front wiper switch HI position signal | Front wiper switch in HI | Below 1 V |
| Front wiper switch off | 11 to 14 V |