Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM › from 2015.08
RM19Y0E _59 Vehicle Exterior _003019 WIPER / WASHER _0015271 WIPER AND WASHER SYSTEM U

WIPER / WASHER  WIPER AND WASHER SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the GTS or Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the GTS or Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS or Techstream on.


d.

Enter the following menus: Body Electrical / Body / Data List.


e.

Read the Data List according to the display on the GTS or Techstream.

Body Electrical > Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
FR wiper HiSW(Main) Front wiper switch high signal ON or OFF ON: Front wiper switch in HI
OFF: Front wiper switch not in HI
-
Rr wiper operation interval time Displays the preset interval time of the rear wiper control function Hi or Normal or Low Customize setting displayed
HINT:
·

Mode1: Hi

·

Mode2: Normal

·

Mode3: Low



Rr wiper INT position operation Displays the preset intermittent operation of the rear wiper Continous or INT Customize setting displayed -
Washer-linked Rr wiper Displays the preset washer-linked operation of the rear wiper Washer-linked or OFF Customize setting displayed -



ACTIVE TEST


HINT:

Using the GTS or Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the GTS or Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS or Techstream on.


d.

Enter the following menus: Body Electrical / Body / Active Test.


e.

Perform the Active Test according to the display on the GTS or Techstream.

Body Electrical > Body > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Rr wiper motor Rear wiper motor assembly ON or OFF -
Fr wiper motor Windshield wiper motor assembly LO or HI -
Fr washer Windshield washer motor and pump assembly ON or OFF -
Rr washer Windshield washer motor and pump assembly ON or OFF -