Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM › from 2015.08
RM19Y0E _59 Vehicle Exterior _003019 WIPER / WASHER _0015271 WIPER AND WASHER SYSTEM J

WIPER / WASHER  WIPER AND WASHER SYSTEM  Power Source Circuit  


DESCRIPTION

This circuit provides power to the wiper and washer system.

WIRING DIAGRAM

E321960E01
1.813,1.135 2.885,1.448 1.073,0.313 10 false from Battery 0.125,0.677 2.708,1.188 2.583,0.51 10 false from Ignition or Starter Switch Assembly 3.854,0.479 4.313,0.677 0.458,0.198 10 false 1 3.823,0.698 4.281,0.896 0.458,0.198 10 false 3H 3.865,0.927 4.323,1.125 0.458,0.198 10 false 1 3.823,1.146 4.281,1.344 0.458,0.198 10 false 3A 4.75,1.417 5.635,1.708 0.885,0.292 10 false IG WIPER 4.448,2.021 5.24,2.375 0.792,0.354 10 false WASHER 4.521,2.458 5.292,2.771 0.771,0.313 10 false RR WIP 4.521,2.896 5.49,3.177 0.969,0.281 10 false FR WIP 4.135,3.375 5.479,4.052 1.344,0.677 10 false to Front Wiper Motor Assembly 4.688,4.156 5.99,4.646 1.302,0.49 10 false to Rear Wiper Motor Assembly 4.094,5.26 6.969,5.573 2.875,0.313 10 false Main Body ECU (Fuse Block Assembly) 6.208,0.688 6.667,0.885 0.458,0.198 10 false E01 6.208,1.854 6.854,2.104 0.646,0.25 10 false WSH

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (FUSE BLOCK ASSEMBLY) POWER SOURCE)
a.

Disconnect the 3A and 3H main body ECU (fuse block assembly) connectors.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
3A-1 - Body ground Always 11 to 14 V
3H-1 - Body ground Ignition switch ON 11 to 14 V



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR