Home › Engine / Hybrid System › 1NR-VE ENGINE CONTROL › SFI SYSTEM › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042271 1NR-VE ENGINE CONTROL _0196149 SFI SYSTEM C

1NR-VE ENGINE CONTROL  SFI SYSTEM  P1605  Unstable Engine Idling  


DESCRIPTION

DTC is output when the engine conditions change from a small load and a stable idle speed to a low idle speed. The freeze frame data, which have memorized the engine conditions when DTC was output, can be checked using the GTS. Because the engine conditions when the idle speed is unstable can be checked by the freeze frame data, vehicle maintenance services can be improved. Moreover, because the idle speed instability due to a lack of fuel is also detected, the fuel level must be checked before operation.

DTC No. Detection Item DTC Detection Condition MIL Memory
P1605 Unstable Engine Idling Either of following condition met:
(1 trip detection logic)

The engine idle speed drops to 400 rpm or less.


- DTC stored

CAUTION / NOTICE / HINT

HINT:
·

When other DTCs are displayed, first troubleshoot the corresponding DTC.

·

Because DTC P1605 differs from the conventional DTC, the following procedure is described as an example.



PROCEDURE

1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P1605)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / EFI / Trouble Codes.


e.

Read DTCs.


Result:
Result Proceed to
DTC P1605 is output A
DTC P1605 and other DTCs are output B



A

2.CHECK FREEZE FRAME DATA

B

2.CHECK FREEZE FRAME DATA
HINT:

Using the time series freeze frame data, check the data when and after the DTC is detected, to be used for troubleshooting.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Check the time series freeze frame data following the instructions displayed on the GTS, and check the vehicle conditions when the idle speed was unstable.

Click hereEngine / Hybrid System>1NR-VE ENGINE CONTROL>SFI SYSTEM>FREEZE FRAME DATA


e.

Check the freeze frame data whether the engine was cool or warmed up.

Tester Display
Engine coolant temperature ECT at engine start


f.

Check the freeze frame data of the engine idling.

Tester Display
Engine revolution speed -


g.

Check the feedback performance status.

Tester Display
Short term fuel trim bank 1 O2S B1S1
Long term fuel trim bank 1 -


h.

Check the freeze frame data of the fuel injection.

Tester Display
Injection volume Injection time


i.

Check the freeze frame data of the engine load/electric load.

Tester Display
Calculated load value Electric load signal 3
Electric load signal 1 A/C magnet clutch relay test
Electric load signal 2 Engine oil pressure SW


j.

Referring to the above freeze frame data, perform the reproduction test.


k.

Based on the freeze frame data and the reproduction test, specify the malfunctioning section while comparing to the reference values shown in the ECM data monitor description.

Click hereEngine / Hybrid System>1NR-VE ENGINE CONTROL>SFI SYSTEM>DATA LIST / ACTIVE TEST


Result:
Result Proceed to
The malfunctioning section can be specified A
The malfunctioning section can not be specified B



A

CHECK AND REPAIR ERROR PART

B