Home › Engine / Hybrid System › 1NR-VE ENGINE CONTROL › THROTTLE BODY › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042271 1NR-VE ENGINE CONTROL _0196152 THROTTLE BODY G

1NR-VE ENGINE CONTROL  THROTTLE BODY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 22030 1.CHECK THROTTLE BODY WITH MOTOR ASSEMBLY

a.

Check the throttle control motor operating sounds.

i.

Turn the ignition switch to ON.


ii.

When depressing the accelerator pedal, check the operating sounds of the motor. Make sure that no friction noise is emitted from the motor.

If any friction noise exists, replace the throttle body with motor assembly.



b.

Check the throttle position sensor.

i.

Connect the GTS or Techstream to the DLC3.


ii.

Turn the ignition switch to ON and turn the GTS or Techstream on.


iii.

Enter the following menus: Powertrain / EFI / Data List / Main throttle position and Sub throttle position.


iv.

When the throttle valve is fully open, check that the Throttle Sensor Position value is within the specification.

Standard throttle valve opening percentage:
Tester Display Specified Condition
Main throttle position
Sub throttle position
60% or higher


CAUTION:

When checking the standard throttle valve opening percentage, the transmnission should be in neutral.


If the percentage is less than 60%, replace the throttle body with motor assembly.