1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
89561
2.REMOVE ECM
Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.
After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.
Disconnect the harness clamp.
Remove the 3 bolts and ECM with ECU bracket.
If a component has been dropped or subjected to a strong impact, replace it.
89539F
3.REMOVE ECU BRACKET
Remove the 4 bolts and ECU bracket from the ECM.