Home › Engine / Hybrid System › 1NR-VE ENGINE CONTROL › ACCELERATOR PEDAL › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042271 1NR-VE ENGINE CONTROL _0196154 ACCELERATOR PEDAL A

1NR-VE ENGINE CONTROL  ACCELERATOR PEDAL  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RHD and LHD sides.

·

The procedure described below is for the LHD side.



PROCEDURE

Hide 78110K 1.REMOVE ACCELERATOR PEDAL SENSOR ASSEMBLY

NOTICE:
·

Avoid physical shock to the accelerator pedal sensor assembly.

·

Do not disassemble the accelerator pedal sensor assembly.

·

The accelerator pedal sensor assembly does not require lubrication.

·

Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.



a.
A364890

Disconnect the accelerator pedal sensor assembly connector.


b.

Remove the 2 bolts and accelerator pedal sensor assembly.