78110K
1.INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY
Connect the GTS or Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the GTS or Techstream on.
Enter the following menus: Powertrain / EFI / Data List / Main accelerator sensor voltage and Sub accelerator sensor voltage.
Read the values displayed on the GTS or Techstream.
| Tester Display | Condition | Specified Condition |
|---|---|---|
| Main accelerator sensor voltage | Accelerator pedal is released | 0.5 to 1.1 V |
| Accelerator pedal is fully depressed | 2.5 to 4.5 V | |
| Sub accelerator sensor voltage | Accelerator pedal is released | 1.2 to 2.0 V |
| Accelerator pedal is fully depressed | 3.4 to 4.7 V |
If the result is not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.