Home › Engine / Hybrid System › 1NR-VE ENGINE CONTROL › MASS AIR FLOW METER › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042271 1NR-VE ENGINE CONTROL _0196155 MASS AIR FLOW METER G

1NR-VE ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

Perform the intake air flow meter assembly inspection according to the procedures below.

·

Only replace the intake air flow meter assembly when the MAF value in the Data List (with the engine stopped) is not within the normal operating range or there is foreign matter on the mass air flow meter platinum hot wire (heater).



PROCEDURE

Hide 1.INSPECT INTAKE AIR FLOW METER ASSEMBLY

a.

Read the value using the GTS or Techstream.

NOTICE:
·

Perform the inspection with the vehicle indoors and on a level surface.

·

Perform the inspection of the intake air flow meter assembly while it is installed to the air cleaner cap assembly (installed in the vehicle).

·

During the test, make sure that the exhaust air duct is not drawing air from the exhaust pipe.



i.

Connect the GTS or Techstream to the DLC3.


ii.

Turn the ignition switch to ON (do not run the engine).


iii.

Turn the GTS or Techstream on.


iv.

Enter the following menus: Powertrain / EFI / Data List / Air flow rate.


v.

Wait for 30 seconds, and read the values on the GTS or Techstream.

Standard:
Tester Display Condition Standard Condition
Air flow rate
·

Engine not running

·

30 seconds after ignition switch is turned to ON


0.31 g/sec or less


If the result is not as specified, replace the intake air flow meter assembly.

If the result is within the specified range, inspect the intake air flow meter assembly (Click hereEngine / Hybrid System>1NR-VE ENGINE CONTROL>MASS AIR FLOW METER>INSPECTION).