Home › Engine / Hybrid System › 1NR-VE ENGINE CONTROL › IGNITION COIL AND SPARK PLUG › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042271 1NR-VE ENGINE CONTROL _0196158 IGNITION COIL AND SPARK PLUG A

1NR-VE ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  INSTALLATION  


PROCEDURE

Hide 19100P 1.INSTALL SPARK PLUG

a.

Install the 4 spark plugs to the cylinder head sub-assembly.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:
·

If a component has been dropped or subjected to a strong impact, replace it.

·

Install the same parts in the same combination to the original locations.




Hide 19500 2.INSTALL IGNITION COIL ASSEMBLY

a.
A285310C03
2.156,0.729 2.469,0.885 0.313,0.156 10 *a 2.156,1.656 2.469,1.813 0.313,0.156 10 *b
*a Ignition Coil Assembly Body
*b Plug Cap


Install the 4 ignition coil assemblies to the cylinder head cover sub-assembly with the 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If a component has been dropped or subjected to a strong impact, replace it.

·

Install the same parts in the same combination to the original locations.




b.

Connect the 4 ignition coil assembly connectors.


c.

Engage the 2 harness clamps and install the wire harness to the cylinder head cover sub-assembly.