19500
1.REMOVE IGNITION COIL ASSEMBLY
Disengage the 2 harness clamps and disconnect the wire harness from the cylinder head cover sub-assembly.
Disconnect the 4 ignition coil assembly connectors.
Remove the 4 bolts and 4 ignition coil assemblies from the cylinder head cover sub-assembly.
If a component has been dropped or subjected to a strong impact, replace it.
Arrange the removed parts in the correct order.
19100P
2.REMOVE SPARK PLUG
Remove the 4 spark plugs from the cylinder head sub-assembly.
If a component has been dropped or subjected to a strong impact, replace it.
Arrange the removed parts in the correct order.