Home › Engine / Hybrid System › 1NR-VE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042271 1NR-VE ENGINE CONTROL _0196159 ENGINE COOLANT TEMPERATURE SENSOR G

1NR-VE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 89422A 1.INSPECT ENGINE COOLANT TEMPERATURE SENSOR

a.
A287154C11
1.823,2.708 2.135,2.292 2.135,2.292 2.365,2.292 false 0.083,0.125 0.396,0.281 0.313,0.156 10 false *a 0.573,1.885 0.885,2.042 0.313,0.156 10 false *b 3,4.104 3.313,4.26 0.313,0.156 10 false *c 2.365,2.188 2.677,2.344 0.313,0.156 10 false *d
*a Component without harness connected
(Engine Coolant Temperature Sensor)
*b Resistance (kΩ)
*c Temperature (°C)
*d Acceptable


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Approximately 20°C (68°F) 2.32 to 2.59 kΩ
Approximately 80°C (176°F) 0.310 to 0.326 kΩ


NOTICE:

When checking the sensor in water, keep the terminals dry. After the check, wipe the sensor dry.


If the result is not as specified, replace the engine coolant temperature sensor.