CHECK DTC
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / EFI / Trouble Codes.
Check the DTC(s) and freeze frame data, and then write them down.
Check the details of the DTC(s).
CLEAR DTC (USING THE GTS)
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / EFI / Trouble Codes.
Clear the DTCs.
CLEAR DTC (WITHOUT USING THE GTS)
Perform either of the following operations:
Disconnect the cable from the negative (-) battery terminal for more than 1 minute.
Remove the EFI fuse from the engine room relay block located inside the engine compartment for more than 1 minute.