Based on transmission revolution sensor (output speed sensor) signals, a microcomputer in the TCM (ECM) calculates the vehicle speed.*
Based on speed sensor signals, a microcomputer in the skid control ECU (brake actuator assembly) calculates the vehicle speed. The ECM receives vehicle speed from the skid control ECU (brake actuator assembly) through the CAN communication lines.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0500 | Vehicle Speed Sensor Signal System | While vehicle being driven, no vehicle speed sensor signal transmitted to ECM
(2 trip detection logic) |
·
CAN communication lines ·
Automatic transmission system* ·
Anti-lock brake system ·
ECM |
Comes on | DTC stored |
*: for Automatic Transmission
Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: System Select / Health Check.
Read the DTCs.
If any DTCs other than P0500, which related to the CAN communication system, automatic transmission system or anti-lock brake system are output, troubleshoot those DTCs first.
| Result | Proceed to |
|---|---|
| DTC P0500 is output (for Automatic Transmission) | A |
| DTC P0500 is output (for Manual Transmission) | B |
| DTC P0500 and other DTCs are output | C |
A
B
C