Home › Engine / Hybrid System › 2NR-VE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042272 2NR-VE ENGINE CONTROL _0196165 CAMSHAFT OIL CONTROL VALVE G

2NR-VE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  INSPECTION  


PROCEDURE

Hide 11101J 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

HINT:

Use the same procedure for the intake side and exhaust side.


a.

Resistance inspection

i.
A171220C03
0.135,0.094 0.448,0.25 0.313,0.156 10 false *a
*a Component without harness connected
(Camshaft Timing Oil Control Valve Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 6.9 to 7.9 Ω


If the result is not as specified, replace the camshaft timing oil control valve assembly.



b.

Movement inspection

i.
A309601C01
0.927,1.146 1.073,0.646 1.073,0.646 1.26,0.646 false 0.073,0.094 0.385,0.25 0.313,0.156 10 false *a 0.563,0.573 0.875,0.729 0.313,0.156 10 false *b 0.573,1.813 0.885,1.969 0.313,0.156 10 false *c 1.313,0.542 1.625,0.698 0.313,0.156 10 false *d
*a Component without harness connected
(Camshaft Timing Oil Control Valve Assembly)
*b When Applied
*c When Cut Off
*d Spool Valve


Connect the positive (+) lead from a battery to terminal 1 and the negative (-) lead to terminal 2, and check the movement of the spool valve.

OK:
Tester Connection Condition Specified Condition
1 - 2 Battery positive (+) voltage is applied Valve moves in direction of left arrow shown in illustration
Battery positive (+) voltage is cut off Valve moves in direction of right arrow shown in illustration


If the result is not as specified, replace the camshaft timing oil control valve assembly.

NOTICE:

Accumulation of foreign matter can cause minor pressure leaks. Minor pressure leaks will cause the camshaft to advance or retard, and this will cause a DTC to be stored.