Home › Engine / Hybrid System › 2NR-VE ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042272 2NR-VE ENGINE CONTROL _0196165 CAMSHAFT OIL CONTROL VALVE G

2NR-VE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 11101J 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

for Exhaust Side

i.

Connect the GTS or Techstream to the DLC3.


ii.

Start the engine.


iii.

Turn the GTS or Techstream on.


iv.

Warm up the engine.


v.

Turn the A/C on.


vi.

Enter the following menus: Powertrain / EFI / Active Test / EX.DVVT Linear.


vii.

Check the engine speed while operating the camshaft timing oil control valve assembly (for exhaust camshaft) using the GTS or Techstream.

OK:
GTS or Techstream Operation Specified Condition
0% Normal engine speed
100% Engine idles roughly or stalls


HINT:
·

If the result is not acceptable, cool the engine (engine coolant temperature is 50°C (122°F) or less) and perform the Active Test again.

·

DTCs related to the VVT system may be stored due to Active Test operation, but this does not indicate a malfunction.



If the result is not as specified, check the camshaft timing oil control valve assembly, wire harness and ECM.



b.

for Intake Side

i.

Connect the GTS or Techstream to the DLC3.


ii.

Start the engine.


iii.

Turn the GTS or Techstream on.


iv.

Warm up the engine.


v.

Turn the A/C on.


vi.

Enter the following menus: Powertrain / EFI / Active Test / IN.DVVT Linear.


vii.

Check the engine speed while operating the camshaft timing oil control valve assembly (for intake camshaft) using the GTS or Techstream.

OK:
GTS or Techstream Operation Specified Condition
0% Normal engine speed
100% Engine idles roughly or stalls


HINT:
·

If the result is not acceptable, cool the engine (engine coolant temperature is 50°C (122°F) or less) and perform the Active Test again.

·

DTCs related to the VVT system may be stored due to Active Test operation, but this does not indicate a malfunction.



If the result is not as specified, check the camshaft timing oil control valve assembly, wire harness and ECM.