Home › Engine / Hybrid System › 2NR-VE ENGINE CONTROL › ACCELERATOR PEDAL › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042272 2NR-VE ENGINE CONTROL _0196168 ACCELERATOR PEDAL G

2NR-VE ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78110K 1.INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY

a.

Connect the GTS or Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS or Techstream on.


d.

Enter the following menus: Powertrain / EFI / Data List / Main accelerator sensor voltage and Sub accelerator sensor voltage.


e.

Read the values displayed on the GTS or Techstream.

Standard Voltage:
Tester Display Condition Specified Condition
Main accelerator sensor voltage Accelerator pedal is released 0.5 to 1.1 V
Accelerator pedal is fully depressed 2.5 to 4.5 V
Sub accelerator sensor voltage Accelerator pedal is released 1.2 to 2.0 V
Accelerator pedal is fully depressed 3.4 to 4.7 V


If the result is not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.