Home › Engine / Hybrid System › 2NR-VE ENGINE CONTROL › MASS AIR FLOW METER › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042272 2NR-VE ENGINE CONTROL _0196169 MASS AIR FLOW METER A

2NR-VE ENGINE CONTROL  MASS AIR FLOW METER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL INTAKE AIR FLOW METER ASSEMBLY

a.

Install the intake air flow meter assembly with the 2 screws.

Torque:
0.97 N*m (10 kgf*cm, 9 in.*lbf)

NOTICE:
·

If a component has been dropped or subjected to a strong impact, replace it.

·

If reusing the intake air flow meter assembly, be sure to inspect the O-ring.

·

Make sure that the O-ring is not damaged or does not jump out of position during installation.




b.

Connect the connector of the intake air flow meter assembly.