Home › Engine / Hybrid System › 2NR-VE ENGINE CONTROL › MASS AIR FLOW METER › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042272 2NR-VE ENGINE CONTROL _0196169 MASS AIR FLOW METER G

2NR-VE ENGINE CONTROL  MASS AIR FLOW METER  INSPECTION  


PROCEDURE

Hide 1.INSPECT INTAKE AIR FLOW METER ASSEMBLY

a.
A278924C05
1.083,0.813 1.51,0.385 1.51,0.385 1.125,0.969 true 1.573,0.229 1.885,0.427 0.313,0.198 10 *a
*a Platinum Hot Wire (Heater)


Perform a visual check for any foreign matter on the platinum hot wire (heater) of the intake air flow meter assembly shown in the illustration.

OK:

There is no foreign matter.


If the result is not as specified, replace the intake air flow meter assembly.


b.
A226758C09
2.438,0.906 2.792,1.354 true 2.521,0.615 2.938,1.344 true 2.208,0.448 2.573,0.646 0.365,0.198 10 false THA 2.25,0.771 2.5,0.969 0.25,0.198 10 false E2 0.031,0.031 0.219,0.26 0.188,0.229 10 false *a
*a Component without harness connected
(Intake Air Flow Meter Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (THA) - 2 (E2) -20°C (-4°F) 13.6 to 18.4 kΩ
20°C (68°F) 2.21 to 2.69 kΩ
60°C (140°F) 0.49 to 0.67 kΩ


If the resistance is not as specified, replace the intake air flow meter assembly.