89465A
1.INSPECT NO. 2 OXYGEN SENSOR (w/ Air Fuel Ratio Sensor)
| *a | Component without harness connected
(No. 2 Oxygen Sensor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (HT1B) - 2 (+B) | 20°C (68°F) | 5.9 to 7.9 Ω |
| 1 (HT1B) - 4 (E2) | Always | 10 kΩ or higher |
If the result is not as specified, replace the No. 2 oxygen sensor.
89465
2.INSPECT OXYGEN SENSOR (w/o Air Fuel Ratio Sensor)
| *a | Component without harness connected
(Oxygen Sensor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (HT1B) - 2 (+B) | 20°C (68°F) | 11.7 to 15.5 Ω |
| 1 (HT1B) - 4 (E2) | Always | 10 kΩ or higher |
If the result is not as specified, replace the oxygen sensor.