Home › Engine / Hybrid System › 1NR-VE ENGINE MECHANICAL › DRIVE BELT › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042273 1NR-VE ENGINE MECHANICAL _0196178 DRIVE BELT A

1NR-VE ENGINE MECHANICAL  DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 16361A 1.INSTALL FAN AND GENERATOR V BELT

a.
A364895C01
0.031,0.031 0.594,0.479 0.563,0.448 10 false *A 0.073,2.354 0.5,2.688 0.427,0.333 10 false *B
*A w/ Air Conditioning System
*B w/o Air Conditioning System


Install the fan and generator V belt as shown in the illustration.

NOTICE:
·

Install the backside of the fan and generator V belt on the V-ribbed belt tensioner pulley.

·

Check that the fan and generator V belt is properly installed to each pulley.




b.
A364896C01
0.042,0.031 0.427,0.313 0.385,0.281 10 false *A 0.083,2.375 0.469,2.667 0.385,0.292 10 false *B
*A w/ Air Conditioning System
*B w/o Air Conditioning System


Turn the V-ribbed belt tensioner assembly counterclockwise and remove the 5 mm hexagon wrench.


c.

After installing the fan and generator V belt, check that it fits properly in the ribbed grooves. Confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley by hand.