Home › Engine / Hybrid System › 2NR-VE ENGINE MECHANICAL › DRIVE BELT › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042274 2NR-VE ENGINE MECHANICAL _0196188 DRIVE BELT A

2NR-VE ENGINE MECHANICAL  DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 16361A 1.INSTALL FAN AND GENERATOR V BELT

a.
A361343

Install the fan and generator V belt as shown in the illustration.

NOTICE:
·

Install the backside of the fan and generator V belt on the V-ribbed belt tensioner pulley.

·

Check that the fan and generator V belt is properly installed to each pulley.




b.
A361344

Turn the V-ribbed belt tensioner assembly counterclockwise and remove the 5 mm hexagon wrench.


c.

After installing the fan and generator V belt, check that it fits properly in the ribbed grooves. Confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley by hand.