13716
1.REMOVE VALVE STEM CAP
Remove the 16 valve stem caps from the cylinder head sub-assembly.
Arrange the removed parts in the correct order.
13711
2.REMOVE INTAKE VALVE
| *a | Wooden Block |
Using SST and wooden blocks, compress and remove the valve spring retainer locks.
Arrange the removed parts in the correct order.
Remove the valve spring retainer, inner compression spring and intake valve.
Arrange the removed parts in the correct order.
13715
3.REMOVE EXHAUST VALVE
| *a | Wooden Block |
Using SST and wooden blocks, compress and remove the valve spring retainer locks.
Arrange the removed parts in the correct order.
Remove the valve spring retainer, inner compression spring and exhaust valve.
Arrange the removed parts in the correct order.
4.REMOVE VALVE STEM OIL SEAL
Using needle-nose pliers, remove the valve stem oil seals.
13734
5.REMOVE VALVE SPRING SEAT
Using compressed air and Magnet Hand, remove the valve spring seats by blowing air onto them.