1.REPLACE RING PIN
It is not necessary to remove the ring pins unless they are being replaced.
Remove the 2 ring pins.
| *a | Upper Side |
| *b | 13 mm (0.512 in.) |
| *c | 12 mm (0.472 in.) |
| *d | 6.5 to 7.5 mm (0.256 to 0.295 in.) |
Using a plastic hammer, tap in the 2 ring pins.
6.5 to 7.5 mm (0.256 to 0.295 in.)
2.REPLACE STRAIGHT PIN
It is not necessary to remove the straight pins unless they are being replaced.
Remove the 4 straight pins.
Using a plastic hammer, tap in the 4 straight pins.
| *a | Front Side | *b | Rear Side |
| *c | 5.5 to 6.5 mm (0.217 to 0.256 in.) | *d | 11.5 to 12.5 mm (0.453 to 0.492 in.) |
| *e | 23.5 to 24.5 mm (0.925 to 0.965 in.) | *f | 4.0 mm (0.157 in.) |
| *g | 12.0 mm (0.472 in.) | *h | 10.0 mm (0.394 in.) |
| *i | 22.0 mm (0.866 in.) | *j | 36.0 mm (1.417 in.) |
| Item | Protrusion Height |
|---|---|
| Pin A | 5.5 to 6.5 mm (0.217 to 0.256 in.) |
| Pin B | 11.5 to 12.5 mm (0.453 to 0.492 in.) |
| Pin C | 23.5 to 24.5 mm (0.925 to 0.965 in.) |