23221
1.INSPECT FUEL PUMP
| *a | Component without harness connected
(Fuel Pump) |
Check the resistance of the fuel pump.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition Specified | Specified Condition |
|---|---|---|
| 1 - 2 | 20°C (68°F) | 0.2 to 3.0 Ω |
If the result is not as specified, replace the fuel pump.
Inspect the operation of the fuel pump.
Connect the positive battery (+) lead to terminal 1 of the connector, and the negative (-) lead to terminal 2. Check that the fuel pump operates.
If the pump does not operate, replace the fuel pump.
These tests must be performed within 10 seconds of connecting the battery to prevent the coil from burning out.
Keep the fuel pump as far away from the battery as possible.
Turn the voltage on and off on the battery side, not the fuel pump side.