77740
1.INSPECT CHARCOAL CANISTER ASSEMBLY
Check the appearance.
Visually check the charcoal canister assembly for cracks or damage.
If cracks or damage are found, replace the charcoal canister assembly.
Check the ventilation.
| *1 | Port A |
| *2 | Port B |
| *3 | Port C |
| *4 | Vacuum Pump |
Using a vacuum pump, check the air flow according to the procedures below.
| Measurement Condition | Specified Condition |
|---|---|
| Ports B and C closed, and vacuum applied to port A (2 kPa (15 mmHg, 0.590 in.Hg)) | No air leaks |
| Port C closed, and vacuum applied to port A (2 kPa (15 mmHg, 0.590 in.Hg)) | Air flows from port B |
| Port C closed and air blown into port A (5.4kPa (0.06 kgf/cm2, 0.783 psi)) | Air flows from port B |
| Air blown into port A (5.4 kPa (0.06 kgf/cm2,0.783 psi)) | Air flows from ports B and C |
If the result is not as specified, replace the charcoal canister assembly.
Check the check valve airtightness.
| *1 | Port A |
| *2 | Port B |
| *3 | Port C |
| *4 | Vacuum Pump |
Engage the vacuum pump to the purge port.
If the result is not as specified, replace the charcoal canister assembly.
| Measurement Condition | Specified Condition |
|---|---|
| Ports A and B closed, and vacuum applied to port C (2 kPa (15 mmHg, 0.590 in.Hg)) | No air leaks |
| Port A closed, and vacuum applied to port C (2 kPa (15 mmHg, 0.590 in.Hg)) | Air flows from port B |
| Port A closed and air blown into port C (5.4kPa (0.06 kgf/cm2, 0.783 psi)) | Air flows from port B |
| Air blown into port C (5.4 kPa (0.06 kgf/cm2,0.783 psi)) | Air flows from ports A and B |
If the result is not as specified, replace the charcoal canister assembly.