Home › Engine / Hybrid System › 1NR-VE EMISSION CONTROL › EMISSION CONTROL SYSTEM › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042277 1NR-VE EMISSION CONTROL _0196211 EMISSION CONTROL SYSTEM G

1NR-VE EMISSION CONTROL  EMISSION CONTROL SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK FUEL CUT RPM

a.

Start and warm up the engine.


b.

Increase the engine speed to at least 3000 rpm.


c.
A360455C01
1.896,1.125 2.094,0.448 2.094,0.448 2.271,0.448 true 2.385,1.25 2.479,1.604 2.479,1.604 2.656,1.604 true 2.302,0.354 2.615,0.51 0.313,0.156 10 true *1 2.698,1.49 3.01,1.646 0.313,0.156 10 false *a
*1 Injector
*a Sound Scope


Use a sound scope to check for injector operating sounds.


d.

When the accelerator pedal is released, check that injector operating sounds stop momentarily and then resume.

If the result is not as specified, check the injectors, wiring and ECM.

Standard:
Item Specified Condition
Fuel injection restart rpm 800 to 1200 rpm



Hide 2.VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS

a.

Visually check that the hoses, connections and gaskets do not have cracks, leaks or damage.

NOTICE:
·

Detachment or other problems with the engine oil dipstick, filler cap, ventilation hose or other components may cause the engine to run improperly.

·

Air suction caused by disconnections, looseness or cracks in any part of the air induction system between the throttle body and cylinder head will cause an engine failure or engine malfunction.



If any defects are found, replace parts as necessary.


Hide 3.INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM

a.

Connect the GTS or Techstream to the DLC3.


b.

Start the engine.


c.

Warm up the engine.


d.

Turn the GTS or Techstream on.


e.

Disconnect the No. 1 charcoal canister outlet hose from the No. 1 vacuum switching valve assembly.


f.

Enter the following menus: Powertrain / EFI / Active Test / Purge VSV.


g.

Check that vacuum occurs at the No. 1 vacuum switching valve assembly port.


h.

If vacuum does not occur, check the following items.

·

No. 1 vacuum switching valve assembly

·

Clogging in the No. 1 charcoal canister outlet hose that connects the intake air surge tank and No. 1 vacuum switching valve assembly

·


i.

Exit Active Test mode and connect the No. 1 charcoal canister outlet hose.


j.

Enter the following menus: Powertrain / EFI / Data List / Evaporative purge output.


k.

Warm up the engine and drive the vehicle.


l.

Confirm that the No. 1 vacuum switching valve assembly opens.

If the result is not as specified, replace the No. 1 vacuum switching valve assembly, wire harness or ECM.