Home › Engine / Hybrid System › 2NR-VE EMISSION CONTROL › PURGE VALVE › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042278 2NR-VE EMISSION CONTROL _0196216 PURGE VALVE G

2NR-VE EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 25860 1.INSPECT NO. 1 VACUUM SWITCHING VALVE ASSEMBLY

a.
A359823

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω


If the result is not as specified, replace the No. 1 vacuum switching valve assembly.


b.
A359824C01
0.698,0.99 0.969,0.99 false 0.833,1.792 0.833,1.604 false 0.521,0.906 0.833,1.063 0.313,0.156 10 false *a 0.781,1.833 1.094,1.99 0.313,0.156 10 false *b 1.219,0.333 1.531,0.49 0.313,0.156 10 false *c
*a Port E
*b Port F
*c Air


Apply battery voltage between the terminals of the No. 1 vacuum switching valve assembly and check that the following occurs when blowing air into port E.

OK:
Measurement Condition Specified Condition
Battery voltage applied between terminals 1 and 2 Air flows from port F
Battery voltage not applied between terminals 1 and 2 Air does not flow


If the result is not as specified, replace the No. 1 vacuum switching valve assembly.