Home › Engine / Hybrid System › 2NR-VE COOLING › RADIATOR › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042282 2NR-VE COOLING _0196242 RADIATOR G

2NR-VE COOLING  RADIATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16401 1.INSPECT FOR RADIATOR CAP SUB-ASSEMBLY

a.
A359831C01
0.469,1.094 0.469,0.823 0.469,0.823 0.896,0.823 true 0.854,1.344 0.854,1.188 0.854,1.188 1.167,1.188 false 1.104,1.594 1.104,1.438 1.104,1.438 1.417,1.438 false 2,1.323 2.375,1.323 false 0.427,1.135 0.74,1.292 0.313,0.156 10 false *1 0.802,1.365 1.115,1.521 0.313,0.156 10 false *2 1.031,1.615 1.344,1.771 0.313,0.156 10 false *3 2.438,1.271 2.75,1.427 0.313,0.156 10 false *4
*1 Rubber Packing 1
*2 Rubber Packing 2
*3 Rubber Packing 3
*4 Lower Plate


Measure the valve opening pressure.

i.

If there are water stains or foreign matter on rubber packings 1, 2 or 3, clean the part(s) with water and finger scouring.


ii.

Check that rubber packings 1, 2 and 3 are not deformed, cracked or swollen.


iii.

Check that rubber packing 3 and lower plate are not stuck together.


iv.

Apply engine coolant to rubber packings 2 and 3 before using the radiator cap tester.


v.

When using the cap tester, tilt it to more than 30 degrees.


vi.
A143091C03
2.063,0.396 1.74,0.917 false 0.49,0.99 0.313,1.177 false 2.073,0.25 2.51,0.604 0.438,0.354 10 false *1 0.156,1.146 0.604,1.542 0.448,0.396 10 false *2 1.781,1.177 2.156,1.479 0.375,0.302 10 false *a
*1 Radiator Cap Tester
*2 Radiator Cap Sub-assembly
*a 30°or more


Pump the cap tester several times, and check the maximum pressure *1.

Pumping speed:

1 pump per second


*1: Even if the cap cannot maintain the maximum pressure, it is not a defect.

Judgement criteria:
Item Specified Condition
Standard value (for brand new cap) 93 to 123 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
Minimum standard value (used cap) 78 kPa (0.8 kgf/cm2, 11.3 psi)


If the maximum pressure is less than the specified pressure for the minimum standard value, replace the radiator cap sub-assembly.