28226B
1.REMOVE REPAIR SERVICE STARTER KIT
Remove the 2 bolts.
| *1 | Starter Drive Lever |
| *2 | Hook |
Remove the hook from the starter drive lever while lifting the rear of the repair service starter kit, and then remove the repair service starter kit.
28120
2.REMOVE STARTER YOKE ASSEMBLY
Remove the 3 through bolts.
Remove the starter yoke assembly.
Remove the rubber seal from the starter yoke assembly.
28130
3.REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY
Remove the starter commutator end frame assembly from the starter yoke assembly.
28140
4.REMOVE STARTER BRUSH HOLDER ASSEMBLY
| *a | Hammer |
Remove the starter yoke assembly while holding down the starter armature assembly and the starter brush holder assembly with the handle of a hammer.
The starter armature assembly will be attracted by the magnetic field of the starter yoke assembly, so the starter armature assembly is held with the handle of the hammer.
28160
5.REMOVE STARTER ARMATURE ASSEMBLY
| *1 | Starter Armature Assembly |
| *2 | Starter Brush Holder Assembly |
Remove the starter armature assembly from the starter brush holder assembly.
28021
6.REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY
Remove the starter center bearing clutch sub-assembly from the starter drive housing assembly.
Disengage the 3 claws and remove the starter internal gear from the starter center bearing clutch sub-assembly.
Remove the 3 starter planetary gears from the starter center bearing clutch sub-assembly.