Home › Engine / Hybrid System › 1NR-VE STARTING › RELAY › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042285 1NR-VE STARTING _0196255 RELAY G

1NR-VE STARTING  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT STARTER RELAY

a.

Remove the No. 1 relay block cover.

Click hereEngine / Hybrid System>1NR-VE ENGINE CONTROL>INTEGRATION RELAY>REMOVAL


b.

Disconnect the No. 1 integration relay.

Click hereEngine / Hybrid System>1NR-VE ENGINE CONTROL>INTEGRATION RELAY>REMOVAL


c.
A360460

Remove the ST No. 2 relay from the No. 1 integration relay.


d.
E209082

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied 10 kΩ or higher
3 - 5 Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the ST No. 2 relay.




e.

Install the ST No. 2 relay to the No. 1 integration relay.


f.

g.