Home › Engine / Hybrid System › 2NR-VE STARTING › STARTER(for Manual Transmission) › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042286 2NR-VE STARTING _0196258 STARTER(for Manual Transmission) A

2NR-VE STARTING  STARTER(for Manual Transmission)  DISASSEMBLY  


PROCEDURE

Hide 28226B 1.REMOVE REPAIR SERVICE STARTER KIT

a.
A359651

Remove the 2 bolts.


b.
A359652C03
1.469,0.542 1.844,0.542 false 1.677,1.344 1.875,1.344 1.875,1.344 1.875,1.073 false 1.875,0.469 2.073,0.625 0.198,0.156 10 false *1 1.51,1.26 1.698,1.427 0.188,0.167 10 false *2
*1 Starter Drive Lever
*2 Hook


Remove the hook from the starter drive lever while lifting the rear of the repair service starter kit, and then remove the repair service starter kit.


Hide 28120 2.REMOVE STARTER YOKE ASSEMBLY

a.
A359653

Remove the 3 through bolts.


b.

Remove the starter yoke assembly.


c.

Remove the rubber seal from the starter yoke assembly.


Hide 28130 3.REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY

a.
A248647

Remove the starter commutator end frame assembly from the starter yoke assembly.


Hide 28140 4.REMOVE STARTER BRUSH HOLDER ASSEMBLY

a.
A296695C02
0.896,0.792 1.51,0.792 false 0.729,0.698 1.042,0.854 0.313,0.156 10 false *a
*a Hammer


Remove the starter yoke assembly while holding down the starter armature assembly and the starter brush holder assembly with the handle of a hammer.

HINT:

The starter armature assembly will be attracted by the magnetic field of the starter yoke assembly, so the starter armature assembly is held with the handle of the hammer.



Hide 28160 5.REMOVE STARTER ARMATURE ASSEMBLY

a.
A248650C03
0.354,0.438 0.542,0.438 0.542,0.438 0.781,0.719 false 1.896,1.458 2.156,1.875 2.156,1.875 2.375,1.875 false 2.448,1.76 2.76,1.917 0.313,0.156 10 false *1 0.146,0.323 0.458,0.479 0.313,0.156 10 false *2
*1 Starter Armature Assembly
*2 Starter Brush Holder Assembly


Remove the starter armature assembly from the starter brush holder assembly.


Hide 28021 6.REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY

a.
A359654

Remove the starter center bearing clutch sub-assembly from the starter drive housing assembly.


b.
A296697

Disengage the 3 claws and remove the starter internal gear from the starter center bearing clutch sub-assembly.


c.
A248654

Remove the 3 starter planetary gears from the starter center bearing clutch sub-assembly.