28021
1.INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY
|
High-temperature Grease |
Apply high-temperature grease to the 3 starter planetary gears and the starter center bearing clutch sub-assembly.
Apply approximately 0.5 g (0.018 oz) of high-temperature grease in total to the starter planetary gear section, end section, and pins without depressions.
| *a | Pins without Depressions |
Install the 3 starter planetary gears to the pins without depressions on the starter center bearing clutch sub-assembly.
Engage the 3 claws and install the starter internal gear to the starter center bearing clutch sub-assembly.
| *1 | Starter Drive Lever |
|
High-temperature Grease |
Apply high-temperature grease to the starter drive lever contact surface.
Apply approximately 0.1 g (0.004 oz) of high-temperature grease to each section.
| *a | Depression |
| *b | Protrusion |
Align the depression in the starter drive housing assembly with the protrusion on the starter center bearing clutch sub-assembly and install the starter center bearing clutch sub-assembly.
Install the rubber seal to the starter drive housing assembly.
28140
2.INSTALL STARTER BRUSH HOLDER ASSEMBLY
Install the starter commutator end frame assembly to the starter brush holder assembly as shown in the illustration.
If the attachment location is not correct, the through bolt cannot be attached.
Spread the brushes on the starter brush holder assembly, and install the starter armature assembly to the starter brush holder assembly.
28160
3.INSTALL STARTER ARMATURE ASSEMBLY
| *a | Hammer |
Install the starter armature assembly and the starter brush holder assembly while holding down the starter yoke assembly with the handle of a hammer.
The starter armature assembly will be attracted by the magnetic field of the starter yoke assembly, so the starter armature assembly is held with the handle of the hammer.
28120
4.INSTALL STARTER YOKE ASSEMBLY
| *a | Protrusion |
| *b | Depression |
Align the depression in the starter yoke assembly with the protrusion on the starter center bearing clutch sub-assembly.
Install the starter yoke assembly with the 3 through bolts.
28226B
5.INSTALL REPAIR SERVICE STARTER KIT
| *1 | Starter Drive Lever |
| *2 | Hook |
Attach the hook on the starter drive lever.
| *1 | Terminal C |
Push down the back of the repair service starter kit and connect it to the terminal C.
Connect the repair service starter kit securely to the terminal C.
Check that the parts are free of foreign matter, oil, or grease.
Install the repair service starter kit with the 2 bolts.