Use the same procedure for the RHD and LHD vehicles.
84790
1.INSPECT REAR WINDOW DEFOGGER SWITCH ASSEMBLY
| *a | Rear Window Defogger Switch Light |
| *b | Component without harness connected
(Rear Window Defogger Switch Assembly) |
Check the rear window defogger switch assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 5 (B) - 4 (E) | Defogger switch On | Below 1 Ω |
| 5 (B) - 4 (E) | Defogger switch Off | 1 MΩ or higher |
Check that the rear window defogger switch light illuminates.
Apply battery voltage to the rear window defogger switch assembly and check that the light illuminates.
| Battery Connection | Switch Condition | Specified Condition |
|---|---|---|
| Battery positive (+) → 3 (L)
Battery negative (-) → 4 (E) |
Defogger switch On | Illuminates |
| Defogger switch Off | Does not Illuminate |
| *a | Rear Window Defogger Illumination Light |
| *b | Component without harness connected
(Rear Window Defogger Switch Assembly) |
Check the rear window defogger illumination light.
Apply battery voltage to the rear window defogger switch assembly and check that the illumination condition.
| Battery Connection | Specified Condition |
|---|---|
| Battery positive (+) → 1 (+)
Battery negative (-) → 2 (-) |
Illuminates |