Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81515B
1.INSPECT FRONT TURN SIGNAL LIGHT SOCKET
| *a | Component without harness connected
(Front Turn Signal Light Socket) |
Apply battery voltage to the terminals and check that the front turn signal light comes on.
| Battery Connection | Condition |
|---|---|
| Battery positive (+) → 1 (+)
Battery negative (-) → 2 (-) |
Front turn signal light comes on |
Use a new bulb or known good one.
81615D
2.INSPECT CLEARANCE LIGHT SOCKET
| *a | Component without harness connected
(Clearance Light Socket) |
Apply battery voltage to the terminals and check that the clearance light comes on.
| Battery Connection | Condition |
|---|---|
| Battery positive (+) → 1 (+)
Battery negative (-) → 2 (-) |
Clearance light comes on |
Use a new bulb or known good one.