Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF DRIP SIDE FINISH MOULDING › from 2015.08
RM19Y0E _59 Vehicle Exterior _003022 EXTERIOR PANELS / TRIM _0015303 ROOF DRIP SIDE FINISH MOULDING A

EXTERIOR PANELS / TRIM  ROOF DRIP SIDE FINISH MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 75561A 1.INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP

NOTICE:
·

If reusing the clips, do not remove the double sided tape remaining on the clips and where the clips will be installed on the body.

·

If installing new clips, remove the double-sided tape remaining where the clips will be installed on the body and clean the body with a non-residue solvent.

·

Follow these procedures only when replacing the clips.



a.
B125568C01
2.552,0.719 2.854,0.875 true 1.604,1.156 1.021,0.792 true 2.875,0.865 3.219,1.167 0.344,0.302 10 *1 0.823,0.646 1.177,0.938 0.354,0.292 10 *a
*1 Adhesive
*a 2 to 3 mm (0.0787 to 0.118 in.) Bead of Adhesive


Apply a 2 to 3 mm (0.0787 to 0.118 in.) bead of adhesive (3M DP-105 or equivalent) to new roof drip side finish moulding clips.

HINT:

Adhesive strength (tensile strength): 13.7 Mpa (140 kgf/cm2, 1987 psi) or more when the temperature is 23°C (73°F).



b.
B407211N01
0.615,0.865 0.771,1.063 0.156,0.198 10 false a 2.708,0.219 2.865,0.417 0.156,0.198 10 false b 1.167,4.177 1.323,4.375 0.156,0.198 10 false c 2.667,3.406 2.823,3.604 0.156,0.198 10 false d

Install new 2 clips in the positions as shown in the illustration. Press in the clips by hand.

Specification:
Area Measurement
a 1.0 to 3.0 mm (0.039 to 0.118 in.)
b 1.2 to 2.2 mm (0.047 to 0.086 in.)
c 1.0 to 3.0 mm (0.039 to 0.118 in.)
d 0.4 to 1.4 mm (0.016 to 0.055 in.)


NOTICE:

After pressing in the clips, wait 30 minutes or more before installing the roof drip side finish moulding.


HINT:
·

Minimum hardening time: 30 minutes.

·

Time needed for complete hardening: 24 hours.




Hide 75552 2.INSTALL ROOF DRIP SIDE FINISH MOULDING LH

a.
B270501

Engage the 2 clips to install the roof drip side finish moulding LH.


b.

Remove the protective tape.