Home › Vehicle Exterior › DOOR / HATCH › HOOD › from 2015.08
RM19Y0E _59 Vehicle Exterior _003017 DOOR / HATCH _0015260 HOOD N

DOOR / HATCH  HOOD  ADJUSTMENT  


CAUTION / NOTICE / HINT

B211130C04
0.667,0.208 1.344,0.698 0.677,0.49 10 *1 2.573,0.219 3.052,0.625 0.479,0.406 10 *2
*1 Centering Bolt
*2 Standard Bolt


HINT:
·

Centering bolts are used to mount the hood hinge and the hood lock. The hood and the hood lock cannot be adjusted with the centering bolts in. Substitute standard bolts for the centering bolts when making adjustments.

·

Use the same procedure for the RHD and LHD vehicles.

·

The procedure listed below is for the LHD vehicle.



PROCEDURE

Hide 53301 1.INSPECT HOOD SUB-ASSEMBLY

a.

Check that the clearance measurements are within the standard ranges.

B411147N01
3.885,0.521 4.052,0.688 0.167,0.167 10 false A 3.427,1.094 3.594,1.26 0.167,0.167 10 true B 0.75,1.49 0.917,1.656 0.167,0.167 10 false C 0.469,2.271 0.635,2.438 0.167,0.167 10 false D 6.094,1.573 6.26,1.74 0.167,0.167 10 false E 3.115,3.667 3.281,3.833 0.167,0.167 10 false F

Standard Clearance (Reference):
Area Measurement Area Measurement
A 7.0 mm
(0.276 in.)
B 3.0 mm
(0.118 in.)
C 2.0 to 5.0 mm
(0.079 to 0.197 in.)
D -1.5 to 1.5 mm
(-0.059 to 0.059 in.)
E 3.7 to 6.7 mm
(0.146 to 0.264 in.)
F 5.5 to 8.5 mm
(0.217 to 0.335 in.)



Hide 53301 2.ADJUST HOOD SUB-ASSEMBLY

a.
B161310

Loosen the 4 hood side hinge bolts.


b.

Move the hood to adjust the clearance to within the standard range.


c.

Tighten the 4 hood side hinge bolts after the adjustment.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


d.
B411148

Adjust the height of the hood front end by turning the 2 center hood cushions.

HINT:

The center hood cushion can be raised and lowered by turning it.



e.

Adjust the hood lock assembly.

i.

Remove the front bumper cover.


ii.

Remove the upper air inlet grille (except Tropic).


iii.

Remove the No. 2 hood lock control cable cover (for Tropic).


iv.
B297765

Loosen the 3 bolts.


v.
B297766

Adjust the hood lock assembly position so that the striker can enter it smoothly.


vi.

Tighten the 3 bolts after the adjustment.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)


vii.

Check that the striker can engage smoothly with the hood lock assembly.