Use the same procedure for the RHD and LHD vehicles.
The procedure listed below is for the RHD vehicle.
85110
1.INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY
| *a | Ceramic Dot |
for RH Side:
Check the stop (park) position.
Operate the windshield wiper motor assembly.
Stop the windshield wiper motor assembly operation.
Check the automatic stop (park) position.
After the windshield wiper motor assembly is stopped, check the automatic stop position after lifting the wiper blade 2 times.
The front wipers stop at the positions shown in the illustration.
| *a | Hood Hinge Cover Edge |
| *b | 35.0 to 45.0 mm (1.377 to 1.771 in.) |
for LH Side:
Check the stop (park) position.
Operate the windshield wiper motor assembly.
Stop the windshield wiper motor assembly operation.
Check the automatic stop (park) position
After the windshield wiper motor assembly is stopped, check the automatic stop position after lifting the wiper blade 2 times.
The front wipers stop at the positions shown in the illustration.