Use the same procedure for the RHD and LHD vehicles.
The procedure listed below is for the RHD vehicle.
85035
1.INSPECT FRONT WASHER NOZZLE
With the engine running, check that the center stream of washer fluid sprays on the windshield within the hatched area shown in the illustration.
| *a | Upper Limit | *b | Lower Limit |
| *c | 485.9 mm (19.12 in.) | *d | 533.5 mm (21.003 in.) |
| *e | 378.3 mm (14.893 in.) | *f | 355.9 mm (14.011 in.) |
| *g | 57.2 mm (2.251 in.) | *h | 81.1 mm (3.192 in.) |
Washer fluid hits the windshield in the area shown in the illustration.
If the result is not as specified, replace the front washer nozzle.