Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH › from 2015.08
RM19Y0E _59 Vehicle Exterior _003020 LIGHTING (EXT) _0015288 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LHD and RHD vehicles.

·

The procedure listed below is for the RHD vehicle.



PROCEDURE

Hide 1.INSPECT TELLTALE LIGHT ASSEMBLY

a.
E321216C01
0.927,0.427 1.302,0.99 true 0.885,1.646 1.281,1.26 true 1.552,1 1.969,0.438 true 0.156,0.115 0.469,0.271 0.313,0.156 10 false *a 0.5,0.333 1.115,0.531 0.615,0.198 10 false HAZ+ 2.052,0.333 2.667,0.531 0.615,0.198 10 false HAZ- 0.75,1.667 1.365,1.865 0.615,0.198 10 false +
*a Component without harness connected
(Telltale Light Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
3 (HAZ-) - 4 (HAZ+) Hazard warning signal switch off 10 kΩ or higher
Hazard warning signal switch on Below 1 Ω


If the result is not as specified, there may be a malfunction in the telltale light assembly.


b.

Apply battery voltage to the connector and check the LED illumination condition.

OK:
Battery Connection Specified Condition
Battery positive (+) → Terminal 8 (+)
Battery negative (-) → Terminal 3 (HAZ-)
LED illuminates


If the result is not as specified, there may be a malfunction in the telltale light assembly.