Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH › from 2015.08
RM19Y0E _59 Vehicle Exterior _003020 LIGHTING (EXT) _0015289 STOP LIGHT SWITCH G

LIGHTING (EXT)  STOP LIGHT SWITCH  INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LHD and RHD vehicles.

·

The procedure listed below is for the RHD vehicle.



PROCEDURE

Hide 84340 1.INSPECT STOP LIGHT SWITCH ASSEMBLY

a.
E321217C01
0.833,0.708 1.396,0.927 true 0.938,1.74 1.333,1.323 true 2.406,1.729 1.948,1.323 true 2.354,0.729 1.896,0.938 true 0.104,0.104 0.417,0.26 0.313,0.156 10 false *a 0.698,0.573 1.01,0.729 0.313,0.156 10 false - 2.49,0.583 2.802,0.74 0.313,0.156 10 false + 2.5,1.677 2.958,1.948 0.458,0.271 10 false CR1 0.573,1.708 1.052,1.948 0.479,0.24 10 false CR2
*a Component without harness connected
(Stop Light Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (+) - 2 (-) Pin not pushed 10 kΩ or higher
3 (CR1) - 4 (CR2) Below 1 Ω
1 (+) - 2 (-) Pin pushed Below 1 Ω
3 (CR1) - 4 (CR2) 10 kΩ or higher


If the result is not as specified, replace the stop light switch assembly.