Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM › from 2015.08
RM19Y0E _58 Vehicle Interior _003012 SEAT BELT _0015223 SEAT BELT WARNING SYSTEM U

SEAT BELT  SEAT BELT WARNING SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS or Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Connect the GTS or Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS or Techstream on.


d.

Enter the following menus: Body Electrical / Body / Data List.


e.

Read the Data List according to the display on the GTS or Techstream.

Body Electrical > Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
IG SW(IG1)(Main) Ignition switch ON signal ON or OFF ON: Ignition switch ON
OFF: Ignition switch off
-
ACC SW(Main) Ignition switch ACC signal ON or OFF ON: Ignition switch ACC
OFF: Ignition switch off
-
Passenger buckle SW Front passenger side seat belt buckle switch signal ON or OFF ON: Front passenger side seat belt fastened
OFF: Front passenger side seat belt not fastened
The front passenger side seat is occupied
Driver buckle SW Driver side seat belt buckle switch ON or OFF ON: Driver side seat belt unfastened
OFF: Driver side seat belt fastened
-



ACTIVE TEST


HINT:

Using the GTS or Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the GTS or Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS or Techstream on.


d.

Enter the following menus: Body Electrical / Meter / Active Test.


e.

Perform the Active Test according to the display on the GTS or Techstream.

Body Electrical > Meter > Active Test
Tester Display Range Measurement Item Diagnostic Note
Indicator 2 DOOR Ind,P Seat Belt, D Seat Belt Corresponding indicator light in combination meter assembly -