CHECK ILLUMINATED ENTRY SYSTEM OPERATION
Perform this inspection with the customize parameters at the initial settings.
When inspecting the following functions, make sure that the map light switch and No. 2 room light switch are in the DOOR position.
The operation and condition of this control are described below.
| Operation | Condition | Lighting |
|---|---|---|
| Fade in and illuminate constantly | ·
Any door is opened when all the doors are closed.*1 ·
Driver side door or front passenger side door is opened when all the doors are closed.*2 |
·
Map light assembly ·
No. 2 room light assembly |
| Illuminate for 15 seconds, and then fade out | When any of the following conditions is met:
·
Any door is unlocked when the ignition switch is off and all the doors are closed and locked. ·
All the doors are closed when any door is opened and the ignition switch is off.*1 ·
Driver side door or front passenger side door is opened and the ignition switch is off.*2 ·
Remove the key from the key cylinder when all doors that operate are closed. |
|
| Fade out immediately | Any of the following conditions is met when the map light is lit:
·
Driver side door is locked when the ignition switch is off and all the doors are closed. ·
The ignition switch is turned from off to ON when all the doors are closed. |
*1: w/ Rear Door Courtesy Light Switch
*2: w/o Rear Door Courtesy Light Switch
INSPECT BATTERY SAVER
Perform this inspection with the customize parameters at the initial settings.
When inspecting the following functions, make sure that the map light switch and No. 2 room light switch are in the DOOR position.
When any door remains open for 10 minutes with the ignition switch off, the lights that operate turn off.*1
When driver side door or front passenger side door remains open for 10 minutes with the ignition switch off, the lights that operate turn off.*2
*1: w/ Rear Door Courtesy Light Switch
*2: w/o Rear Door Courtesy Light Switch
INSPECT ROOM LIGHT SYSTEM BATTERY SAVING
Perform this inspection with the customize parameters at the initial settings.
When the map light assembly and No. 2 room light assembly are left on with the ignition switch off,they will automatically go off after 12 minutes.