Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM › from 2015.08
RM19Y0E _58 Vehicle Interior _003007 LIGHTING (INT) _0015198 LIGHTING SYSTEM W

LIGHTING (INT)  LIGHTING SYSTEM  CUSTOMIZE PARAMETERS  


CUSTOMIZE LIGHTING SYSTEM (INT)


a.

Customizing using the GTS or Techstream

HINT:

The following items can be customized.


NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



i.

Connect the GTS or Techstream to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS or Techstream on.


iv.

Enter the following menus: Customize Setting / Room lamp.


v.

Select the setting by referring to the table below.

Room lamp
Display Default Content Setting Relevant ECU
Room lamp illumination time Long Changes the lighting time after closing all of the doors (It will fade out immediately when turning the ignition switch from off to ACC or ON). 00:Long,01:Short Main body ECU (fuse block assembly)
Room lamp IG OFF illumination ON A function that turns on the interior lights when the ignition switch is turned from ON or ACC to off (the interior lights turn on when the map light switch and No. 2 room light switch are set to DOOR). 00:ON,01:OFF Main body ECU (fuse block assembly)