Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM › from 2015.08
RM19Y0E _58 Vehicle Interior _003007 LIGHTING (INT) _0015198 LIGHTING SYSTEM U

LIGHTING (INT)  LIGHTING SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the GTS or Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the GTS or Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS or Techstream on.


d.

Enter the following menus: Body Electrical / Body / Data List.


e.

Read the Data List according to the display on the GTS or Techstream.

Body Electrical / Body / Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
IG SW(IG1)(Main) Ignition switch ON signal ON or OFF ON: Ignition switch ON
OFF: Ignition switch off
-
KEY SW Key switch on signal ON or OFF ON: Key is inserted into ignition key cylinder
OFF: Key is removed from ignition key cylinder
-
Lock SW Front door lock assembly RH*1 or LH*2 lock signal ON or OFF ON: Driver side door locked
OFF: Driver side door unlocked
-
Unlock SW Front door lock assembly RH*1 or LH*2 unlock signal ON or OFF ON: Driver side door unlocked
OFF: Driver side door locked
-
Driver door courtesy SW Courtesy light switch (for driver side) signal ON or OFF ON: Driver side door open
OFF: Driver side door closed
-
Back door courtesy SW Back door courtesy light switch signal ON or OFF ON: Back door open
OFF: Back door closed
-
ACC SW(Main) Ignition switch ACC signal ON or OFF ON: Ignition switch ACC
OFF: Ignition switch off
-
RH rear courtesy SW*3 Courtesy light switch (for rear RH side) signal ON or OFF ON: Rear RH side door open
OFF: Rear RH side door closed
-
LH rear courtesy SW*3 Courtesy light switch (for rear LH side) signal ON or OFF ON: Rear LH side door open
OFF: Rear LH side door closed
-
Passenger courtesy SW Courtesy light switch (for front passenger side) signal ON or OFF ON: Front passenger side door open
OFF: Front passenger side door closed
-

*1: for RHD

*2: for LHD

*3: w/ Rear Door Courtesy Light Switch




ACTIVE TEST


HINT:

Using the GTS or Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Connect the GTS or Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS or Techstream on.


d.

Enter the following menus: Body Electrical / Body / Active Test.


e.

Read the Data List according to the display on the GTS or Techstream.

Body Electrical / Body / Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Dome lamp/room lamp Map light assembly and No. 2 room light assembly OFF/OFF, OFF/ON, ON/OFF, ON/ON Turn the map light switch and No. 2 room light switch to the DOOR position.