Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM › from 2015.08
RM19Y0E _59 Vehicle Exterior _003016 WINDOW / GLASS _0015247 POWER WINDOW CONTROL SYSTEM L

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  PRECAUTION  


POWER WINDOW CONTROL SYSTEM PRECAUTIONS


NOTICE:
·

The power window control system prohibits the auto up and down function when the jam protection function malfunctions.

·

If the battery has been disconnected, the connector has been disconnected from the power window regulator master switch assembly, or POWER B fuse in main body ECU (fuse block assembly) has been removed, initialize the power window control system.

·

If the power window regulator motor assembly RH*1 or LH*2 (for front side) has been replaced, initialize the power window control system.

·

If the power window regulator motor assembly RH*1 or LH*2 (for front side) has been removed and installed, or if the power window regulator motor assembly RH*1 or LH*2 (for front side) was reused when the door glass or door glass run was replaced, initialize the power window control system.

·

After a door glass or door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up feature is used due to detection of a door glass moving speed value different from the learned value. In this case, initialize the power window control system.

·

The jam protection function may operate unexpectedly even when the power window control system is normal due to detection of a value different from the learned value when the moving speed of door glass changes sharply under any of the following conditions:

1.

A power window is being opened or closed while the vehicle is driven on a rough road.

2.

A power window is being opened or closed while the door is being opened or closed.

3.

The voltage changes abruptly.




*1: for RHD

*2: for LHD