If the battery has been disconnected, the connector has been disconnected from the power window regulator master switch assembly, power window regulator motor assembly RH*1 or LH*2 (for front side), or POWER B fuse in main body ECU (fuse block assembly) has been removed, initialize the power window control system.
If the power window regulator master switch assembly, power window regulator motor assembly RH*1 or LH*2 (for front side) have been replaced, initialize the power window control system.
When the window regulator sub-assembly, door glass or door glass run was replaced even if the power window regulator motor assembly RH*1 or LH*2 (for front side) was reused, initialize the power window control system.
Auto operations, jam protection and key-off operations do not function without the power window system initialization.
*1: for RHD
*2: for LHD
INITIALIZE POWER WINDOW CONTROL SYSTEM (DRIVER SIDE DOOR)
Manually or automatically open the power window more than one-quarter by pushing the power window regulator master switch assembly.
This operation is not necessary when the power window is already open more than one-quarter.
Close the power window by fully pulling up and holding the power window regulator master switch assembly, and keep the switch up for 2 seconds or more.
Confirm that the power window does not lower when the switch is released. If the power window lowers, initialization is not completed. If so, perform the initialization again after disconnecting the negative (-) battery terminal for 10 seconds or more.
In case the power window cannot be initialized even after performing the procedures above, keep the switch up at auto up position for 12 seconds after the power window is fully closed.
PTC may affect to stop the power window system by prolonged switch operation, and auto and remote operations may become inoperative for a certain period. In this case, leave the vehicle for a while before restarting the initialization.