POWER WINDOW OPERATION IN FAIL-SAFE MODE
If the pulse sensor built into the power window regulator motor assembly RH*1 or LH*2 (for front side) malfunctions, the power window control system enters fail-safe mode.
*1: for RHD
*2: for LHD
The power window control system prohibits the following power window operation when the pulse sensor for the jam protection function has problems and the window position or the learned value is abnormal.
| Power Window Operation | Ignition switch ON | Ignition switch off
(key-off operation permitted) |
Ignition switch off
(key-off operation prohibited) |
|---|---|---|---|
| Manual up | X | X | X |
| Manual down | ○ | X | X |
| Auto up
(hold switch at auto up position) |
○* | X | X |
| Auto down
(hold switch at auto down position) |
○* | X | X |
| Auto up | X | X | X |
| Auto down | X | X | X |
○: Operates
X: Operation prohibited
*: Operates in manual mode without jam protection